|
Automatic
Ventilation Blower
The
ASR-50-AB Automatic Ventilation Blower is an optional component
that you can install in your underground blast-resistant shelter
that will automatically draw air into, and out of your shelter -
providing true ventilation. The purpose of this device is to automatically
remove moisture, stale air, and odors (and minimize mold and mildew)
from your protected space while it is not in use. It does this by
drawing air into your shelter - which pressurizes it - and then
that air is expelled through the outlet vent.
It
is easily installed with the included wall mount bracket and the
quick-release hose that is included with the Safe Cell is simply
pulled off the intake port of the Safe Cell and put on the blower
with a slight twisting motion. The timer is set to run for a few
minutes every day to automatically ventilate the shelter. In an
NBC event, the occupants simply remove the hose from the ventilation
blower and install it onto the Safe Cell and then turn on the Safe
Cell - this can be done in a few seconds.
The
blower is a rated for continuous duty and can be used as a backup
blower for the Safe Cell. All it takes is to remove it from the
mounting bracket with a slight twisting motion and then slip it
into the top of the Safe Cell, turn on the switch, and you have
a backup blower that will suck air through the internal blower of
the Safe Cell and expel safe, breathable air into your protected
space.

Shown
above is the Automatic Ventilation Blower plumbed into the intake
Blast Valve.
Note
the timer on the electrical outlet that turns the blower on and
off at regular intervals to automatically ventilate your blast shelter
without loading the filters in the Safe Cell with particulates or
moisture.
In
the picture above, the intake port of the Safe Cell has the red
shipping cap installed on it to prevent particulates and moisture
from loading the filters in the Safe Cell. This is the normal installation
that you should have in your underground shelter - until you occupy
it. On the Safe Cell
page, you will see the hose connected to the intake port of the
filtration system. It literally takes a few seconds to change this
connection.
Everything
you need is included in this kit:
-
An Installation and operation manual
- A
heavy-duty 110-volt AC or 12-volt DC blower with switch and fuse
protection
-
A custom fabricated mounting bracket with quick-release (slip
fit) connections for both the hose and the blower
- A
heavy-duty grounded manual timer
- The
lag bolts and washers for mounting on a wall
ASR-50-AB
Automatic Ventilation Blower: $575.00 each.

Click on the button above to order
|